News_HeNan YONAI Refractories Co., Ltd.

News

Location:Home > News
  • Thermal Conductivity Of Refractory Materials...

    Time:2017-10-21
    Thermal conductivity is the amount of heat which flows from the hot face to the cold face of a refractory lining. It plays an important and critical role in the performance of refractory materials in structures such as high temperature process vessels, furnaces, kilns, etc....
  • Selection Principle Of Refractory...

    Time:2017-10-21
    Before the selections of refractory, below factors need to be known at first:
  • Important Factors To Consider When Installing Refract...

    Time:2017-10-21
    Proper installation of the refractory is as important as selection of the right material for the service life and safe operation of the furnace.
  • Refractory industry background

    Time:2017-10-21
    Refractory material is a typical big industry, small company pattern. Although many refractory enterprises in China, but the concentration is very low. Currently resistant to domestic market space about 100 billion, 2015, the first 10 refractory enterprises market share of less than 15%...
  • The reasons of Black heart of Refractory brick...

    Time:2017-10-21
    Black heart is a high alumina brick production is prone to a phenomenon. The characteristics of this brick, brick profile color gradually changes from the surface of the yellow-green to the internal gray-black transition. If this black heart brick in the oxidizing atmosphere to re-calcined, black heart can be re-burn white part....
  • Analysis on Casting Method of Corundum Brick...

    Time:2017-10-21
    The shrinkage is concentrated in a certain area, after annealing with a diamond saw to remove him, the remaining useful part of the composition of uniform, dense tissue, the average density of the density close to the theoretical density; the other is cutting the cast leg method: from the reduction of cutting area The castings are cast into "L" type...
  • AZS Ramming Mass AZSM-06J

    Time:2017-10-21
    Open the bag to check if the coagulant agent is dampened or hardened, and then spread the coagulant agent uniformly into the bag;


common7Article point1Page Page15 Article Home Previous Next Last Page Go to